Fiberglass Pool Repair in Santa Fe, NM
A fiberglass pool has a gelcoat surface rather than plaster, and it fails differently under Santa Fe's high-altitude sun. Here is what goes wrong, what each repair involves, and what we handle honestly.
What a fiberglass shell is, and how to tell it from plaster or vinyl
A fiberglass pool is a one-piece molded shell with a smooth gelcoat finish. It is not plaster (which is a troweled cement surface over gunite) and it is not vinyl (a flexible liner in a framed wall). If the surface is smooth, slightly glossy and uniform in color, and the pool has a molded one-piece look with no tile line at the waterline, it is almost certainly fiberglass.
The gelcoat is a thin resin layer that gives the pool its color and shine. Underneath is the fiberglass structure itself. The gelcoat is the part that fades, chalks and cracks; the fiberglass under it is the part that gives the shell its strength.
What goes wrong with a fiberglass pool in Santa Fe
- Gelcoat fading and chalking — at 7,000 feet the UV is intense. The gelcoat fades, then turns chalky and dull. This is cosmetic, not structural, but it is the most common complaint.
- Spider cracks (crazing) — a network of fine surface cracks in the gelcoat, usually from stress or age. They do not leak, but they look bad and hold algae.
- Blisters and osmosis — water penetrates the gelcoat and forms a blister. This is osmosis, and it means the gelcoat barrier has failed in that spot.
- Cracked skimmer or return fitting — the molded fittings can crack with freeze-thaw cycling, and a crack here leaks.
- Waterline spotting — a ring of stain or scale at the waterline that is hard to remove without damaging the gelcoat.
Why a fiberglass pool must never be acid washed or drained casually
An acid wash strips the gelcoat. A fiberglass pool that is acid washed will lose its surface finish and be rougher and more prone to algae than before. The correct way to clean a stained fiberglass surface is a gentle gelcoat-safe cleaner and careful brushing, not acid.
Draining a fiberglass pool is also riskier than draining a plaster one. A fiberglass shell is light, and a high water table or saturated soil after a Santa Fe monsoon can push an empty shell out of the ground. If a fiberglass pool must be drained, it should be done with care and refilled promptly.
Surface repair versus structural repair
A surface repair is gelcoat work: sanding, filling, and re-gelcoating a faded, cracked or blistered area. It restores the look and the barrier. A structural repair is fiberglass work: laying new fiberglass cloth and resin over a crack or blister that has gone through the gelcoat into the structure. Surface repair is cosmetic and protective; structural repair is about stopping a leak or a failure that compromises the shell.
What we do, and what is specialist work
Our chemistry, filtration and equipment service keeps a fiberglass pool healthy. The right water balance, a clean filter and a running pump prevent the staining, scaling and algae that make gelcoat problems worse. That is the work we do, and we do it well.
Gelcoat refinishing and structural fiberglass repair are specialist work. We will assess your pool with you and tell you straight away whether the problem is something we handle — chemistry, equipment, filtration — or whether it needs a fiberglass specialist. We would rather say so than sell you a repair we are not equipped to do properly.
We serve fiberglass pools across Santa Fe, NM and the surrounding communities — including Eldorado, Tesuque, La Cienega, Agua Fria, Pojoaque and Lamy. Call 505-805-2917 and we will tell you straight away whether it is work we take on.
Need Fiberglass Pool Repair in Santa Fe?
We will look at your pool and tell you honestly what it needs and whether it is work we take on.